The following maintenance work shall be carried out for the energy-saving circular cooling tower
Release time:
2024-03-14 00:00
Source:
Energy-saving circular cooling tower refers to the equipment in which cooling water and air are in direct contact for cold and heat exchange. After the pumps and pipes of the energy-saving circular cooling tower have been used for a period of time, the following maintenance work should be carried out:
(1) Drain the remaining water in the pump and pipeline.
(2) If it is convenient to disassemble, the pump and pipeline can be disassembled and cleaned.
(3) Check the ball bearing. If the inner sheath and outer sheath are worn, loose, the ball is worn or there are spots on the surface, please replace them. Bearings are cleaned with gasoline or kerosene and lubricated for storage.
(4) Check whether there are cracks or small holes on the impeller, and whether the fixing nut of the impeller is loose. If damaged, it should be repaired or replaced. Check the clearance on the impeller antifriction ring. If it exceeds the specified value, repair or replace it immediately.
(5) If the pump and pipeline are not disassembled, the outlet should be sealed with a cover to prevent debris from entering.
(6) When the energy-saving circular cooling tower does not use the conveyor belt, please remove the conveyor belt, clean and dry it with warm water, and then store it in a place without direct sunlight, and do not store it in oily, corrosive and corrosive places. Smoking. In any case, do not put oil, diesel or gasoline on the tape, and do not apply rosin or other sticky materials on the tape. Before using the tape, remove the white powder on the contact surface of the tape.
(7) Clean all screws and bolts with a wire brush, and coat them with engine oil, or immerse them in diesel oil for storage.
Only by doing a good job of maintenance can the failure rate of the new energy-saving cooling tower be reduced and the service life of the equipment be extended. Hope everyone can help.
Previous Page
Next Page
Related News
Influence of different inlet and outlet water temperature on type selection of cooling tower
Different inlet and outlet water temperatures have a certain influence on the selection of cooling towers. A cooling tower is a device used to cool industrial processes. Its main function is to reduce the temperature of the system through the evaporation of water.
Factory must see: what is the cooling tower filler? And maintenance methods!
For the summer factory, there is a very important thing-cooling tower filler. It is mainly a material used in the cooling tower, when it comes to the cooling tower, it can also be understood as a cooling effect from the literal meaning. Today we will explore what is the cooling tower filler?
The water (hot water) that needs to be cooled is splashed into water droplets or a water film is formed to increase the contact area and time between water and air and promote the heat exchange between water and air. The cooling process of water is mainly carried out in the filling of water.
Understand the structure of the packing support plate
The packing support plate is an important structure for supporting the packing, which has the characteristics of good stability and strong durability. This paper introduces the structure, composition and operation principle of the filler support plate, and points out that it has wide application prospects in the fields of chemical industry, pharmacy, petroleum, metallurgy and so on.
Function of Packing Support Plate in Packed Tower
This can improve the mass transfer efficiency and reaction efficiency of the packed column.
What are the advantages of closed cooling towers over traditional open cooling towers?
The open cooling tower uses the circulating water to spray on the packing of the cooling tower in a spraying manner. After the water contacts with air, heat exchange is achieved, and then the air flow in the tower is driven by the fan to circulate, and the hot air flow after heat exchange with water is brought out and then reaches the cooling target. The closed cooling tower uses the contact between water and the coil to take away the heat of the cooling medium in the coil through the heat transfer of the outer wall of the coil to reach the heat exchange.